Finding the Thermal Conductivity of a Good Conductor Using Searle's Bar

Apparatus

Constant-head apparatus, measuring cylinder, stop watch, Searle's apparatus, steam generator, four thermometers T 1 , T 2 , T 3 , T 4 , Vernier callipers.

T 1 and T 2 measure the temperature at points on the bar, T 3 and T 4 measure the temperature of water entering and leaving the spiral C.

Method

2. Pass steam from the steam generator through the steam chest. wait until the thermometers have reached a steady state (i.e. no significant increase or reduction of temperature for 10 minutes).

3. Measure T 1 , T 2 , T 3 and T 4 .

4. Measure the rate of water flow through the spiral by measuring the amount of water (m) collected in the measuring cylinder in a given time (t). Collect approximately 1 litre.

5. Using Vernier callipers, measure the diameter of the bar D and the distance d between the thermometers T 1 and T 2 .

Theory

Assuming no loss of heat along the bar, it can be shown that:

where:

Q is the heat supplied to the bar in time t,

A is the cross-sectional area of the bar,

dT is the difference in temperature between two points in the bar dx apart,

k is the coefficient of thermal conductivity of the bar.

The heat Q warms up a mass m (in kilograms) of water from temperature T 4 to T 3 according to the formula:

where c is the specific heat capacity of water (c = 4190 J kg -1 K -1 ).

Using: ,(d in metres), and (A in metres squared) we obtain:

(in W m -1 K -1 ).

Error Calculation

1. There is an error in assuming that no heat lost along the bar, but no correction has been made for this, although this will obviously affect the values of T 2 and T 1 .

2. The absolute error in each of the temperature differencesandis the sum of the absolute errors in reading the two thermometers.

3. Errors in m arise from errors in determining the mass of water collected.

4. Errors in the time t depend on the accuracy of the stop-watch.

5. Errors in measuring with the Vernier calliper are at least 0.05 mm, but may be bigger (estimate how precisely you can measure D and d).

The fractional error in k is given by:.